Mar 31, 2016 When you install Mac OS X on a non-Apple hardware device called a Hackintosh, you are likely to face the problem of “Still waiting for root device”. This is the message you get when you try to boot Mac OS X. This message illustrates that the disk containing the OS X image is not booting properly. Dec 18, 2018 Hackintosh or Macintosh installation shows this error: still waiting for root device while installation, here you can fix this problem 100%. With refrence of. Dec 18, 2018 Hackintosh or Macintosh installation shows this error: still waiting for root device while installation, here you can fix this problem 100%. With refrence of. Jun 30, 2011 When trying to boot off that drive I still get the 'Still Waiting for Root Device Error' Any help would be appreciated. 2 HDDs, 1 IDE (Snow Leopard, Primary Master), 1 SATA (Ubuntu/Windows 7) IDE DVD drive (Primary Slave).
I've had fairly good luck cloning Macs using Disk Utility and a Thunderbolt cable. Recently I ran into one stubborn one that wouldn't boot up properly after the re-image.
![]()
It went straight to a flashing Do Not Enter symbol. That was a bit confusing. Was there a physical connection problem with the drive? I could boot into recovery mode (Cmd-R), and that was fine—and in recovery mode I could see the newly-imaged partition. Rebooted again. Same deal with the Do Not Enter symbol. Maybe it was just a bad image.
Imaged from another machine. Same deal. Let me boot into verbose mode (Cmd-V) to see what's going on.
I got Still waiting for root device repeated. Same deal if I tried to boot into single-user mode (Cmd-S).
When I Googled 'still waiting for root device,' all the top results had to do with Hackintoshes and not native iMacs. even if I Googled 'still waiting for root device imac,' all the top results have to do with Hackintoshes. Not very helpful, since this is a genuine Apple computer I'm working with.
Just on a lark. I held down the Option key at boot-up to see what drives were available. This actually got me somewhere, because I saw two options—Macintosh HD and the name of the partition I had just imaged. Now usually (and this is how it appears in Disk Utility in recovery mode) there is a larger disk called Macintosh HD with a partition underneath it. When that's the case, holding down the Option key at boot-up will show you only the bootable partition underneath.
Os X Still Waiting For Root Device
When I tried to boot to Macintosh HD, I got the Do Not Enter sign again.
When I booted to the newly created partition, it booted just fine, though.
I had to explicitly select it at boot, though, every time. So I knew something was funky with the filesystem.
So I thought maybe I could just change the Startup Disk to use the working partition. When I tried to do that I got an error message that said you can't change the startup disk to the selected disk building boot caches on boot helper partition failed. None of the Google searching on that phrase helped me fix the issue.
I tried a fresh reinstall of OS X through recovery mode, but that failed:
Then I tried to see if I could verify and repair the disk using Disk Utility:
It said, after I tried to repair it that I had to repair it. Thanks.
I am new to Mac and did not want to Mess up my new Mac. Firefox 64 for mac os x el capitan 10.11.6. The site downloaded Version 38.3.0.dmg. Anyone know if this version will install on El Capitan?Have been afraid to try as it was mentioned earlier that only OS X 10.10 was supported.
So I tried repairing it using recovery mode.
Same deal. And same deal using the iMac in target disk mode (T) and then running Disk Utility repair on it from another Mac.
No matter what I did—trying to repair the drive, or to delete and re-create partitions; the partition table was super messed up, for whatever reason.
Now, I don't know if this is the solution, but it ended up being a working solution, even though it took a really long time! What I ended up doing was—instead of using Disk Utility—straight up copying entire partitions off another iMac to get the partition table corrected. C programming software for mac os x.
So I put the troublesome iMac in target disk mode. Same deal for a working iMac. And then I had a third iMac I hooked each of those into using Thunderbolt cables.
In the terminal, I used
to get all of the actual disks/partitions in question. There were three listed for each. I started with the top and just went down—copying disk8 to disk5 and then disk7 to disk4. Here's an example:
sudo dd if=/dev/disk7 of=/dev/disk4 bs=128m conv=noerror,sync
Be very careful using the dd command. It can be very destructive if you don't know what you're doing. if is the input filesystem and
![]() Still Waiting For Root Device
Overall, across a Thunderbolt connection, it took about two full days (48 hours) to complete a 1 TB drive transfer.. but it worked! (Your mileage may vary.)
Mac os x lion theme for ubuntu 14.04 download. Apr 23, 2014 MAC OS X Theme for Ubuntu 14.04 Trusty Tahr. How to get Ubuntu 14.04/14.10 (Linux) on Mac OS X (Dual Boot) - Duration. MAC OS X Lion Theme in Lubuntu (LXDE). Mac OS X transformation pack is ready for Ubuntu 14.04 Trusty Tahr. Credit also goes to bluedxca93 from gnome-look.org who helped us with fixing several bugs in the themes (checkout his work, and he also accept donations). Following instructions you can completely change look of your Ubuntu 14.04 LTS to look like Mac. Jun 16, 2014 Instead you can give it a makeover and make Ubuntu 14.04 look like Mac OS X. Make Ubuntu 14.04 look like Mac OS X. To give Ubuntu a makeover of Mac, we shall be using Zukimac theme. Get Zukimac theme from the link below: Download Zukimac Theme for Ubuntu 14.04; Extract the downloaded zipped file. Apr 23, 2014 Install Mac OS X Theme for Ubuntu 14.04 will help to make Ubuntu 14.04 looks like Mac OS X.This Macbuntu Transformation Pack Includes GTK Themes, themes for Ubuntu Unity, Icon themes for Ubuntu 14.04, Logos, Boot Splash sceen, Login Screen LightDM webkit theme (by wattos).This pack is developed by noobslab with the help of bluedxca93 from gnome-look.org.
P.S. Once it was done, I was able to boot into single-user mode, run an fsck to clean the filesystem, and then reboot into normal mode and verify the disk from Disk Utility with no errors.
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2020
Categories |